Telecoms, Datacoms, Wireless, IoT


Sub-GHz wireless IP mesh networking modules

23 October 2019 Telecoms, Datacoms, Wireless, IoT

RIIM (Radiocrafts IP Mesh) is an embedded RF system designed by Radiocrafts to be an all-inclusive, easy-to-use mesh with direct IP addressing. The technology employs the IEEE802.15.4 g/e RF protocol and includes an Intelligent C-programmable I/O (ICI), which makes it possible to directly interface to any sensor or actuator. It also supports Mist Computing and does not require any licence or subscription fee.

RIIM is a 2-way symmetric wireless mesh network at 868/915 MHz with the complete IP mesh included in the module and with automatic network setup. RIIM is capable of sending and receiving data directly over the Internet, making it easy to connect to cloud services and other devices. The modules are inherently low-power modules with automatic power saving functions enabling battery operation.

A RIIM leaf node can be put in ‘Sleepy Node’ mode and only wake up when there is activity to report or read. The node is still active on the network, but in a very low level just to maintain the dynamic network. The average current tested for a ‘Sleepy Node’ in standby is 8 µA, which will enable coin cell battery operation or energy harvesting solutions. A node can last 10 years on a CR2772 (870 mAh capacity coin cell battery) while sending 12 Bytes every hour, 24 hours per day.

The RC1882CEF-IPM RIIM module can be configured as a border router, mesh router, or a leaf node:

• As a border router node, it acts as the base of the mesh network. It can connect to an external network via Ethernet or custom user applications on other interfaces such as UART.

• As a mesh router node, it is a full-featured node that is able to re-transmit packets to other nodes in the RIIM mesh network.

• As a leaf node, it is a full-featured node that is not able to re-transmit packets to other nodes. This configuration uses the least amount of energy.

For more information contact Gyula Wendler, Altron Arrow, +27 11 923 9709, [email protected], www.altronarrow.com


Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

General-purpose evaluation board
Altron Arrow DSP, Micros & Memory
Based on the 32-bit Arm Cortex-M7 S32K3 MCU in a 172 HDQFP package, the S32K3X4EVB-T172 offers dual cores configured in lockstep mode, ASIL D safety hardware, and HSE security engine.

Read more...
Zero drift current shunt monitors
Altron Arrow Power Electronics / Power Management
The NCS21671 and NCV21671 from onsemi are a series of voltage output current sense amplifiers offered in gains of 25, 50, 100, and 200 V/V.

Read more...
Quectel increases its IoT antenna range
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
Quectel has expanded its IoT antenna portfolio with six new 4G and 5G antennas that cover a wide range of use cases.

Read more...
Webinar: Game-changing Matter standard
EBV Electrolink Telecoms, Datacoms, Wireless, IoT
Join Infineon for an exclusive one-hour webinar with EBV Elektronik, exploring the groundbreaking Matter standard, and its profound implications for the future of smart homes.

Read more...
Wi-Fi 6/BLE module enables rapid development
Altron Arrow Telecoms, Datacoms, Wireless, IoT
Telit Cinterion has announced the WE310K6, a fully integrated, low-power module featuring dual-band, dual-stream Wi-Fi 6, and dual-mode Bluetooth/BLE.

Read more...
Low phase noise amplifier
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
The MAAL-011158 from Macom is an easy-to-use low-phase noise amplifier that provides 12 dB of gain in a 32-lead QFN plastic package.

Read more...
Webinar: Enabling the digital transformation of IIoT with Bluetooth
Telecoms, Datacoms, Wireless, IoT
Key industrial use cases for Bluetooth will be reviewed, including the main performance requirements for Bluetooth in industrial applications, and the technical features available.

Read more...
Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Analysis of switch-mode power supply: inductor violations
Altron Arrow Editor's Choice Power Electronics / Power Management
Common switch-mode power supply (SMPS) design errors are discussed, and their appropriate rectification is specified, with details on complications that arise with the power stage design of DC-DC switching regulators.

Read more...
Microsoft Windows IoT on ARM
Altron Arrow Computer/Embedded Technology
This expansion means that the Windows IoT ecosystem can now harness the power of ARM processors, known for their energy efficiency and versatility.

Read more...