Analogue, Mixed Signal, LSI


Low-power real-time clock

31 July 2019 Analogue, Mixed Signal, LSI

The MAX31341B nanoPower real-time clock (RTC) from Maxim Integrated Products enables designers of space-constrained systems such as wearables, medical monitors, point-of-sale (POS) equipment and portable terminals to extend battery life as well as save power and space.

The device, which operates at less than 180 nA, offloads the central microcontroller from timekeeping, allowing for greater energy savings during sleep cycles and extension of battery runtime. Available in an ultra-small wafer-level package measuring 2 x 1,5 mm, the RTC allows a typical lithium coin-cell battery to last for more than 10 years in the battery backup mode.

For more information contact CST Electronics, +27 11 608 0070, [email protected], www.cstelectronics.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Banana Pi with NPU
CST Electronics AI & ML
The latest Banana Pi SBC, the BPI-M7, is powered by Rockchip’s latest flagship RK3588 octa-core 64-bit processor, with a maximum frequency of 2,4 GHz.

Read more...
Hardened-grade network switches
CST Electronics Computer/Embedded Technology
Lantronix’s hardened switches provide Layer 2 or Layer 3 networking, and are available as Power-over-Ethernet (PoE) or Power-over-Ethernet Plus (PoE+).

Read more...
Energy measurement IC
CST Electronics Power Electronics / Power Management
The SY7T501 and SY7T502 are Silergy’s newest energy measurement ICs for cost-sensitive IoT applications such as smart-plugs, dimmers, power-strips, intelligent lighting, and other points of load.

Read more...
Easy wireless mesh networking
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has announced three new NeoMesh Click boards that are ideal for wireless mesh networking, eliminating the need for engineers to create any development PCB hardware themselves.

Read more...
LoRa transceiver module
CST Electronics Telecoms, Datacoms, Wireless, IoT
The RYLR896 transceiver module from REYAX features the LoRa long range modem that provides ultra-long range spread spectrum communication.

Read more...
High-performance antenna solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
The Spitfire Series of antennas delivers exceptional performance with its dipole design, ground plane independence, and easy wall-mount versatility for both indoor and outdoor environments.

Read more...
SMD antenna for GNSS L1 band
CST Electronics Telecoms, Datacoms, Wireless, IoT
Antenova has recently launched the Admotus SMD antenna, a ceramic antenna suitable for all GNSS positioning applications in the L1 band covering 1559 to 1609 MHz.

Read more...
High-speed PIN diode
Altron Arrow Analogue, Mixed Signal, LSI
Vishay’s new high-speed Silicon PIN diode is able to detect both visible and near infra-red radiation over a wide spectrum range from 350 to 1100 nm.

Read more...
Analogue front end for sensor measurements
Electrocomp Analogue, Mixed Signal, LSI
The NJU9103 AFE from Nisshinbo is a tiny analogue front end, with a 16-bit resolution ADC and up to 512 x signal amplification from the programmable gain amplifier.

Read more...