Clearline’s single- and three-phase trip-connect lightning and surge protection units with programmable delay are used to protect any electrical installation from damage due to lightning or large fluctuations in supply voltages.
When the supply voltage is too low or too high, the unit will disconnect power to the downstream equipment, and will then automatically restore power after a preset delay when the supply returns to acceptable levels. Various modules are available for loads up to 115 A and the units are supplied with internal contactors up to 65 A.
The units perform cycle by cycle RMS voltage measurements, providing protection against over- and under-voltage conditions. They incorporate similar technology and designs to that of an automatic voltage regulator. These devices are installed between the incoming supply and the distribution board or equipment. Typically these protection systems are suitable for domestic, commercial and industrial applications.
The three-phase tripconnect system is particularly useful when protecting large equipment such as motors, pumps, refrigeration and air conditioning systems.
Clearing the Static: Understanding the significance of ESD audits Actum Electronics
Circuit & System Protection
An ESD (Electrostatic Discharge) audit is the first step in establishing an ESD plan, and it is important to include all areas where ESD-sensitive components are being handled.
Read more...Microchip introduces ECC608 TrustMANAGER Altron Arrow
Circuit & System Protection
To increase security on IoT products and facilitate easier setup and management, Microchip Technology has added the ECC608 TrustMANAGER with Kudelski IoT keySTREAM, Software as a Service (SaaS) to its Trust Platform portfolio of devices, services and tools.
Read more...Varistors for automotive applications Future Electronics
Circuit & System Protection
TDK Corporation has announced the addition of two new varistors to its AVRH series for automotive applications where both are characterised by the high electrostatic discharge-withstanding voltage demanded to ensure the safe operation of safety-critical automotive functions.
Read more...Single-phase EMC filters RS South Africa
Circuit & System Protection
TDK Corporation has expanded its portfolio of single-phase EMC filters for AC and DC applications up to 250 V and rated currents from 6 to 30 A.
Read more...Clearing the Static: ESD protective packaging Actum Group
Circuit & System Protection
The primary objective of ESD protective packaging is to prevent ESD incidents within the packaging and facilitate the dissipation of charges from the outer surface.
Read more...New NeoMesh protocol stack version CST Electronics
Circuit & System Protection
NeoCortec has released an updated NeoMesh protocol stack version 1.6 firmware for its NC2400 and NC1000 module series, which now supports the new Sensirion SHT4xA temperature and humidity sensor series.
Read more...NewFeed feeder protection relay NewElec Pretoria
Circuit & System Protection
The NewFeed Feeder Protection Relay has been designed to protect the connection between solar farms and conventional power grids in both low voltage (LV) and medium voltage (MV) distribution settings.
printer friendly version