The KSG200 cable connector housing from Erni is intended for use with the TMC series, D-Sub connectors to DIN 41612, MIL-C-24308 and IEC 807-3. It was designed to fulfil high ESD requirements and to provide shielding against EMI/RFI in accordance with latest EMC laws. ESD protection is essential for high performance data transfer at high frequencies.
The cable connector housing and the knurled screw heads are made of high performance plastic. Operating temperature range is -65 to 185°C. To improve EMI/RFI shielding, two shielding plates are riveted to the half-shells of the housing. These plates were specially designed after extensive testing which allows a very high level of shield attenuation - at 100 MHz more than -66 dB and at 500 MHz better than -55 dB. In comparison, a metallised housing offers approximately -55 and -45 dB respectively. The lamellar indents of the shielding plates at the contact points to the TMC connector and to the strain relief make a major contribution to this high shielding level. The strain relief also connects the braided shield of the cable to the shielding plates. Cables up to 11 mm diameter may be used.
A further major advantage of the housing is fast and easy assembly by means of snap latches on the two half-shells. Fixing screw/s prevent them from separating (eg, if the housing is dropped onto the floor). For servicing, the two half-shells can easily be disassembled by removing the screw/s.
There are four housings sizes - 9, 15, 25 and 37 pins - and a complete kit includes the knurled screws.
Prefitted junction box solutions
Interconnection
Prepopulated junction boxes in popular terminal configurations, such as single- and three-phase, enhance convenience for both electrical wholesalers and contractors.
Read more...Bulgin unveils new range of sustainable connectors Avnet Abacus
Interconnection
The Standard Vitalis Buccaneer range of waterproof connectors is a bio-based alternative to Bulgin’s flagship series, the Standard Buccaneer, offering the same technical performance with improved sustainability.
Read more...Possible copper cable crisis looms as global demand soars
Interconnection
With the world requiring up to 3 billion metric tons of copper by 2050 to support green energy transitions and developing nations’ infrastructure, far exceeding the 23 million metric tons mined in 2024, pressure on supply chains is mounting.
Read more...High-reliability spring-loaded interconnects Spectrum Concepts
Interconnection
These springs from Mill-Max are drop-in replacements for the standard springs, requiring no changes to the form or fit of the existing spring-loaded pins.
Read more...Connectors for the Smart Factory Spectrum Concepts
Interconnection
[Sponsored] Designing networks for the smart factory can seem daunting, but the solutions are already available with Samtec providing a comprehensive range of interconnect technologies tailored to the demands of the modern factory.
Read more...Explosive zone connectors
Interconnection
The connector series design by Glenair is optimised for fast and easy crimp-contact wire termination, with ample wiring space in the cable housing and accessory hardware.
While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.
printer friendly version