Opto-Electronics


Light sensors for pick-and-place robots

23 October 2013 Opto-Electronics

The Leuze LPS 36 light section sensor offers resolution down to 0,1 mm making it ideally suited for the measurement of small parts. Capable of operating in applications with height intervals from 200 mm to 600 mm, the Leuze LPS 36 HI/EN line profile sensor is a cost effective and reliable manner for the detection of parts that are smaller than 3 mm.

For example, on a line 140 mm in length, this sensor can ascertain the dimensions of small parts in a very short measurement time of 10 ms and with a high measurement rate of 100 Hz, and this at a high resolution of 0,1 to 0,9 mm.

The transmission of the measurement data as well as the configuration of the sensor is done via Ethernet. An additional connection for standard incremental encoders supports the creation of calibrated 3D data. This makes these sensors well suited for creating solutions for robot controls in pick-and-place applications as well as for positioning tasks in packaging and assembly areas.

The robust construction of the sensors allows reliable sensing in harsh operating conditions.

For more information contact Countapulse Controls, +27 (0)11 615 7556, [email protected], www.countapulse.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

PhotoMOS relays
Future Electronics Opto-Electronics
The AQY221R2SX and AQY221R2S PhotoMOS from Panasonic Industry ensures excellent characteristics and high-speed switching performance.

Read more...
Mouser now shipping onsemi’s image sensors
TRX Electronics Opto-Electronics
The AR0145CS is a 1/4,3-inch CMOS digital image sensor with a 1280 (H) x 800 (V) active-pixel array that can capture both continuous video and single frames.

Read more...
Adaptive optics’ power solution
Altron Arrow Opto-Electronics
Vicor power-dense adaptive optical modules enable colossal telescopes to look into the past for deep space discoveries.

Read more...
Ultra-high speed photo detection
Opto-Electronics
TDK Corporation has announced a photo-spintronic conversion element combining optical, electronic, and magnetic elements that can respond at an ultra-high speed of 20 picoseconds.

Read more...
High-speed lasers
RFiber Solutions Opto-Electronics
Macom are a high-volume manufacturer of lasers, deploying more than 100 million devices with a reliability of less than 50 FIT and greater than 100 years of wear-out lifetime

Read more...
High-performance optical interconnect
Opto-Electronics
STMicroelectronics has unveiled its next generation of proprietary technologies for higher-performing optical interconnect in datacentres and AI clusters.

Read more...
Halo mid-board optical transceiver
Spectrum Concepts Opto-Electronics
The Samtec Halo mid-board transceiver has been designed for next-generation embedded applications that require 56 and 112 Gbps PAM4 performance in low profile and ruggedised form factors.

Read more...
New generation of Ethernet media converters
IOT Electronics Opto-Electronics
Phoenix Contact is introducing three new families of media converters to the market, each designed for specific industrial environments and challenges.

Read more...
PIN photodiode with integrated lens
RFiber Solutions Opto-Electronics
The MARP-BP112 from Macom is a backside-illuminated PIN photodiode, usable from 1200 nm to 1650 nm, that is optimised for use in 112 GBaud PAM4 applications.

Read more...
RGBIR sensor with I2C interface
Electrocomp Opto-Electronics
Available in a miniature opaque 2,67 x 2,45 mm package, Vishay’s VEML6046X00 includes high-sensitivity photodiodes, a low noise amplifier, and a 16-bit analogue to digital converter.

Read more...