Computer/Embedded Technology


4-port serial PCIe MiniCard

9 October 2013 Computer/Embedded Technology

New from Diamond Systems is the DS-MPE-SER4OPT, a rugged, low cost serial port module in the PCIe MiniCard form factor measuring 30 x 51 mm. The board offers four RS-232/RS-485 opto-isolated serial ports in this popular form factor.

Each port offers 16C550 compatibility and 256-Byte TX/RX FIFOs. Maximum data rates are 1 Mbps in RS-232 mode and 10 Mbps in RS-485 mode. The board is available preconfigured for four RS-232 ports, four RS-485 ports or a combination of four RS-232 and four RS-485 ports. I/O signals are provided on two miniature latching connectors, with two ports per connector.

Each pair of serial ports on the DS-MPE-SER4OPT offers up to 500 V isolation from the system ground. Opto-isolation increases reliability in applications with long cable runs, where a difference in ground potential can cause significant ground loop currents, damaging non-isolated boards and equipment.

Isolation on this miniature board is achieved through a combination of highly integrated isolated power + data components, careful component placement and layout, and a safety-enhancing insulation film on the bottom side, which prevents accidental contact with components on the carrier board.

Extended temperature capability of -40°C to +85°C enables the board to operate in environments with extreme temperature swings, such as vehicles or outdoor installations. In addition, the board may be custom-configured with 0-ohm resistors in place of jumper blocks for increased ruggedness in high-vibration environments.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Generate waveforms at 10 GS/s
Vepac Electronics Computer/Embedded Technology
New flagship arbitrary waveform generator cards from Spectrum Instrumentation generate waveforms with 2,5 GHz bandwidth and 16-bit vertical resolution.

Read more...
Quad-port 10GBASE-T controller
Rugged Interconnect Technologies Computer/Embedded Technology
he SN4-DJEMBE, available from Rugged Interconnect, is a networking adaptor card for CompactPCI Serial systems, equipped with four individual controllers for 10GBASE-T.

Read more...
HPE policy management platform
Computer/Embedded Technology
Duxbury Networking has announced the availability of the HPE Aruba ClearPass policy management platform, that enables business and personal devices to connect to an organisational level, in compliance with corporate security policies.

Read more...
IoT gateways
Brandwagon Distribution Computer/Embedded Technology
IoT Gateways are hardware and software devices that are responsible for collecting data from connected devices, managing communication between devices and the cloud, and processing and analysing the data before sending it to the cloud for further analysis.

Read more...
1.6T Ethernet IP solution to drive AI and hyperscale data centre chips
Computer/Embedded Technology
As artificial intelligence (AI) workloads continue to grow exponentially, and hyperscale data centres become the backbone of our digital infrastructure, the need for faster and more efficient communication technologies becomes imperative. 1.6T Ethernet will rapidly be replacing 400G and 800G Ethernet as the backbone of hyperscale data centres.

Read more...
Keeping it cool within the edge data centre
Computer/Embedded Technology
The creation of more data brings with it the corresponding need for more compute power and more data centres, which, in turn, can create unique challenges with regards to securing the environment and cooling the IT loads.

Read more...
NEX XON becomes Fortinet partner
NEC XON Computer/Embedded Technology
This designation demonstrates NEC XON’s ability to expertly deploy, operate, and maintain its own end-to-end security solutions, helping organisations to achieve digital acceleration.

Read more...
Online tool for data centre planning and design
Computer/Embedded Technology
Vertiv has unveiled a new tool, Vertiv Modular Designer Lite, designed to transform and simplify the configuration of prefabricated modular (PFM) data centres.

Read more...
Mission computer for HADES
Rugged Interconnect Technologies Computer/Embedded Technology
North Atlantic Industries’ latest product, the SIU34S, has been selected as the mission computer for the High Accuracy Detection and Exploitation System (HADES) program.

Read more...
14th Gen power to boost AI at the edge
Rugged Interconnect Technologies Computer/Embedded Technology
ADLINK’s inclusion of Intel’s 14th generation Core processors into its latest embedded boards and fanless computers is set to boost the AI and graphics capabilities.

Read more...