Analogue, Mixed Signal, LSI


Fixed attenuators extending to 18 GHz

7 August 2013 Analogue, Mixed Signal, LSI

Attenuation has saved many systems and circuit designs, especially when it can be added in precise, consistent amounts. Attenuation comes in many forms and sizes, but perhaps few packages that are smaller than the new 2 x 2 mm chip-sized YAT-Series fixed attenuators from Mini-Circuits. They are available in 1 dB increments from 0 through 10 dB, and with as much as 30 dB attenuation packed into the housing.

With a frequency range of DC to 18 GHz, the YAT series can serve a wide range of commercial, industrial and military applications, including cellular and wireless communications systems and in radar and electronic warfare (EW) equipment. In spite of their diminutive size, the attenuators can handle as much as 2 W (+33 dBm) while still effectively dissipating any heat generated as a result of the RF/microwave power.

The devices are miniature 50 Ω passive components that can be added to a design to reduce signal levels, to increase isolation between different sections, or to improve impedance-match and return-loss performance. They are available in attenuation values through 30 dB, with minimal attenuation above and beyond their rated attenuation values.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

AC-DC brick PSU
Conical Technologies Power Electronics / Power Management
These PSUs have a typical efficiency of up to 92%, and a power factor value of up to 0,99. They are available in 12, 24, 28, 48 and 54 V output versions.

Read more...
5 kW switching PSU range
Conical Technologies Power Electronics / Power Management
Mornsun has released a new switching power supply range, the LMF5000-25Bxx, which has a 5000 W capacity, and features universal AC input configurations.

Read more...
Parallel redundancy power module
Conical Technologies Power Electronics / Power Management
The LIR40-40 is a wide input range DC-DC module, with a constant output of 48 V at a nominal output current of up to 40 A.

Read more...
Multi-channel electronic load series
Conical Technologies Power Electronics / Power Management
ITECH has recently announced the release of their upgraded IT8700P+ series multi-channel electronic loads. This new series supports master-slave parallel configuration between all the modules, allowing for different modules to be mixed and matched for synchronisation.

Read more...
PV DC-DC converter
Conical Technologies Power Electronics / Power Management
This new series from Mornsun is designed for renewable energy applications, and boasts an ultra-wide and ultra-high 300 to 1500 V DC.

Read more...
High-voltage PSUs for optic applications
Conical Technologies Power Electronics / Power Management
For all applications in electronic optics, it is crucial to have a reliable power supply or capacitor charger, with high precision, stability, and efficiency.

Read more...
High-speed PIN diode
Altron Arrow Analogue, Mixed Signal, LSI
Vishay’s new high-speed Silicon PIN diode is able to detect both visible and near infra-red radiation over a wide spectrum range from 350 to 1100 nm.

Read more...
DC/DC converters with ultra-wide input range
Conical Technologies Power Electronics / Power Management
The THN 15UIR and THN 20UIR series from Traco are high-performance DC/DC converters with an ultra-wide 12:1 input voltage range and a power output of 15 and 20 W respectively.

Read more...
Analogue front end for sensor measurements
Electrocomp Analogue, Mixed Signal, LSI
The NJU9103 AFE from Nisshinbo is a tiny analogue front end, with a 16-bit resolution ADC and up to 512 x signal amplification from the programmable gain amplifier.

Read more...
Graphical source measure unit
Conical Technologies Test & Measurement
The IT2800 Series from ITECH are compact and cost-effective bench-top source measure units with the capability to source and measure both voltage and current.

Read more...