LNAs have high dynamic range

7 April 2004 Analogue, Mixed Signal, LSI

Four high IP3 GaAs MMIC low noise amplifiers from Hittite Microwave for receiver applications in wireless basestations operate from a single positive supply, feature a noise figure of 1 dB or less, and an output IP3 of up to +38 dBm. The HMC356LP3 exhibits 1,0 dB noise figure, 17 dB gain and +38 dBm output IP3, and is designed for GSM and CDMA cellular basestation and mobile radio front-end receivers from 350 to 550 MHz. For GSM and CDMA cellular applications, the HMC372LP3 and HMC373LP3 are rated from 700 and 1000 MHz, and offer 1,0 dB noise figure, 14 dB gain, with +33 dBm and +35 dBm of output IP3 respectively. The HMC373LP3 also offers an amplifier bypass mode which exhibits only 2 dB of loss and +50 dBm of output IP3, while consuming only 10 µA of bias current. The HMC375LP3 is intended for GSM, CDMA and W-CDMA basestation front-end receivers between 1,7 and 2,2 GHz. It has 17 dB of gain, 0,9 dB noise figure, and an output IP3 of +33 dBm.

RF Design, 021 762 5365.

Further reading:

Infineon launches Edge Ai software solution
Altron Arrow Analogue, Mixed Signal, LSI
Infineon has introduced DEEPCRAFT, a new software solution category brand for Edge AI and machine learning, after the company recognised the huge potential of Edge AI for the market.

Read more...

---

16-bit voltage output denseDAC
Altron Arrow Analogue, Mixed Signal, LSI
The AD5766 uses a versatile four-wire serial interface that operates at clock rates of up to 50 MHz for write mode, and is compatible with SPI, QSPI, MICROWIRE, and DSP interface standards.

Read more...

---

AFE enables the software-defined factory
Avnet Silica Analogue, Mixed Signal, LSI
With its software configurable analogue inputs, where each input can be configured for voltage, current, resistance, or temperature, NXP’s N-AFE enables a new level of flexibility.

Read more...

---

Precision voltage reference
Altron Arrow Analogue, Mixed Signal, LSI
The ADR1001 is a fully integrated, ultra-low drift, buried Zener precision voltage reference solution in a single chip.

Read more...

---

Microphones enable low-power always-on state
Avnet Abacus Analogue, Mixed Signal, LSI
TDK Corporation has announced its InvenSense SmartSound T5848 I2S microphones to enable intelligent keyword, voice command, and sound detection at ultra-low power.

Read more...

---

Low power, low-noise amplifier
Altron Arrow Analogue, Mixed Signal, LSI
The ADL8141 is a low power consumption, low-noise amplifier that operates from 14 to 24 GHz, and draws a supply current of 25 mA from a 2 V supply.

Read more...

---

QLC Flash memory with the latest BiCS technology
EBV Electrolink Analogue, Mixed Signal, LSI
KIOXIA has implemented the groundbreaking CBA (CMOS directly Bonded to Array) technology, which enables the creation of higher density devices and an industry-leading interface speed of 3,6nbsp;Gbps.

Read more...

---

Precision op-amp
Altron Arrow Analogue, Mixed Signal, LSI
The ADA4099-1 and ADA4099-2 are single/dual robust, precision, rail-to-rail input/output operational amplifiers with inputs that operate from -VS to +VS and beyond, which is referred to as Over-The-Top.

Read more...

---

Using linear regulators as a filter
Altron Arrow Editor's Choice Analogue, Mixed Signal, LSI
Different circuits can be used to filter a supply voltage, and this article explains the main differences between using an LC filter and a linear regulator for filtering.

Read more...

---

High-speed PIN diode
Altron Arrow Analogue, Mixed Signal, LSI
Vishay’s new high-speed Silicon PIN diode is able to detect both visible and near infra-red radiation over a wide spectrum range from 350 to 1100 nm.

Read more...

---