Analogue, Mixed Signal, LSI


New family of MEMS gyroscopes

2 September 2009 Analogue, Mixed Signal, LSI

STMicroelectronics has introduced a new family of single- and multi-axis MEMS (micro electromechanical systems) gyroscopes for angular-motion detection in human-machine interface applications, personal and car navigation systems, and image stabilisation for digital still and video cameras.

The new devices boast excellent stability over a wide temperature range and time, with variation typically lower than 0,05 dps/°C for zero-rate level, eliminating the need for further temperature compensation in the application. Measurement precision is ensured with the negligible level of noise that affects the output signal – 0,014 dps/sqrt(Hz) at 30 dps full-scale.

Housed in a 5 x 5 mm LGA package, the gyroscopes are resistant to mechanical stress and are able to operate with any supply voltage in the range of 2,7 to 3,6 V. Devices are available with full scales ranging from 30 dps to 6000 dps. Examples include the LPR503AL, a two-axis pitch-and-roll gyroscope with 30 dps and 120 dps full scales, and the LPY550AL, a two-axis pitch-and-yaw gyroscope with 500 dps and 2 000 dps full scales.





Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

16-bit voltage output denseDAC
Altron Arrow Analogue, Mixed Signal, LSI
The AD5766 uses a versatile four-wire serial interface that operates at clock rates of up to 50 MHz for write mode, and is compatible with SPI, QSPI, MICROWIRE, and DSP interface standards.

Read more...
AFE enables the software-defined factory
Avnet Silica Analogue, Mixed Signal, LSI
With its software configurable analogue inputs, where each input can be configured for voltage, current, resistance, or temperature, NXP’s N-AFE enables a new level of flexibility.

Read more...
Precision voltage reference
Altron Arrow Analogue, Mixed Signal, LSI
The ADR1001 is a fully integrated, ultra-low drift, buried Zener precision voltage reference solution in a single chip.

Read more...
Microphones enable low-power always-on state
Avnet Abacus Analogue, Mixed Signal, LSI
TDK Corporation has announced its InvenSense SmartSound T5848 I2S microphones to enable intelligent keyword, voice command, and sound detection at ultra-low power.

Read more...
Low power, low-noise amplifier
Altron Arrow Analogue, Mixed Signal, LSI
The ADL8141 is a low power consumption, low-noise amplifier that operates from 14 to 24 GHz, and draws a supply current of 25 mA from a 2 V supply.

Read more...
QLC Flash memory with the latest BiCS technology
EBV Electrolink Analogue, Mixed Signal, LSI
KIOXIA has implemented the groundbreaking CBA (CMOS directly Bonded to Array) technology, which enables the creation of higher density devices and an industry-leading interface speed of 3,6nbsp;Gbps.

Read more...
Precision op-amp
Altron Arrow Analogue, Mixed Signal, LSI
The ADA4099-1 and ADA4099-2 are single/dual robust, precision, rail-to-rail input/output operational amplifiers with inputs that operate from -VS to +VS and beyond, which is referred to as Over-The-Top.

Read more...
Using linear regulators as a filter
Altron Arrow Editor's Choice Analogue, Mixed Signal, LSI
Different circuits can be used to filter a supply voltage, and this article explains the main differences between using an LC filter and a linear regulator for filtering.

Read more...
High-speed PIN diode
Altron Arrow Analogue, Mixed Signal, LSI
Vishay’s new high-speed Silicon PIN diode is able to detect both visible and near infra-red radiation over a wide spectrum range from 350 to 1100 nm.

Read more...
Analogue front end for sensor measurements
Electrocomp Analogue, Mixed Signal, LSI
The NJU9103 AFE from Nisshinbo is a tiny analogue front end, with a 16-bit resolution ADC and up to 512 x signal amplification from the programmable gain amplifier.

Read more...